Why it matters

A four-week window with no spare days

A combine harvester works in conditions that would be considered a dust test anywhere else: chaff, straw dust and soil fines, all day, for weeks. There is no convenient moment to lose a machine to an element change.

Farm workshops and dealers usually run a handful of machines rather than a fleet, which makes the per-unit economics simpler: one cleaner covers every tractor, harvester and telehandler on the yard.

Cleaning as part of the shift routine

Clean at the end of the day, when the machine is already stopped
Same procedure on every machine, so seasonal staff can be shown once
Clean before winter storage — dust left in the pleats draws moisture and cakes over the off-season
No electrical supply needed in a field workshop or a lean-to

Where it fits

Tractors, combine harvesters, telehandlers and sprayers use cylindrical engine elements that sit inside the 100–300 mm range. Cab and HVAC filters are panel type and are not part of this job.

Which elements fit
Tractor engine element	Fits — 100–300 mm bore range
Combine harvester engine element	Fits — check bore on larger machines
Telehandler / sprayer element	Fits — typical bore in range
Cab / HVAC filter	No — panel type

Not sure about your element? Send the model number or a photo with a ruler in frame and we will confirm the fit before you order.

On the bay

How the job runs.

The same four steps every time, which is the point — the result should not depend on who is on shift.

Pull the element

Remove it at the end of the shift and knock off the loose chaff.

Set the plate

Centre it on the base plate and set the arms to the bore.

Clean at regulated pressure

Inside out, full circumference, at a pressure the paper tolerates.

Inspect and refit

Light behind the element. Refit if sound, replace if the media is gone.

Questions

Asked by agriculture workshops.

Can I clean an element that has been in storage all winter?

If it was stored dry and the media is intact, yes. If dust was left in the pleats and has drawn moisture, inspect carefully — caked or mouldy media should be replaced, not cleaned.

Does it work off a small compressor?

It needs a workshop air line at a usable pressure rather than a large volume. Set the regulator to suit the element; the gauge shows what you are actually applying.

Is one unit enough for a farm workshop?

For a mixed fleet of tractors, a harvester and a telehandler, one unit is normally enough — cleaning is done at the end of a shift, not continuously.

Quotation

Equipping a farm workshop or dealership?

Tell us the machine mix you support and whether you also supply elements. We can quote single units, dealer quantities or a private-label programme.

Request a quote

Fields marked * are required.